GYPSUM PLASTER WITH PERLITE
SIVA is a gypsum based,
specially formulated
ready-to-use bagged plaster
that can be applied directly to
brick, concrete, aerated
concrete, etc.
It has high strength, surface
hardness and adherence.
SIVA does not slump while
setting on the surfaces to
which it is applied.
Because it is a breathable
material, by regulating
humidity SIVA leads to a
healthier environment.
It is a non-combustible
material. The water in its
structure helps to retard fire.
Its long workability time
enables an easy application
with a low waste rate.
Before application, clean off all dust and dirt as it may cause poor bonding.
Pour 6-6,5 L of water into a clean bowl. Add 10 kg of SIVA slowly until it covers the water surface. Wait few minutes, then mix until a lump-free, doughlike mortar is achieved.
After mixing, the mortar is ready to use. The mortar in the bowl can be used for approximately 1 hour. To apply, use a straightedge profiled plastering trowel and a steel spatula. Scrape off any residues after they set.
SIVA can be applied as a single 5-40 mm thick layer onto brick, concrete and aerated-concrete wall surfaces and 5-20 mm thick layer onto ceilings and exposed concrete surfaces.
Do not use at temperatures below 5°C. The surfaces of the dry and hot layers must be moistened to death.
Never mix SIVA with any other product or material (except SATEN).
Use a low-speed mechanical mixer.
Do not apply SIVA in layers less than 5 mm thick.
Do not add any water or plaster to the mortar after mixing.
Do not use SIVA in temperatures below + 5°C.
Bags must be stored in a dry place and should not be stacked more than 20 bags high.
Do not allow bags to be in contact with the ground or with moisture.
Use SIVA within 1 year of the date of manufacture. Poor storage conditions or exceeding the shelf-life may cause the physical properties of SIVA to deteriorate.
Water/Plaster ratio ............ 6–6.5 L of water to 10 kg of SIVA
Setting time start ...................................... > 20 minutes
Workability ...................................................... 60 minutes
Final setting time ......................................... 150 minutes
Coverage ............. 9-9,5 kg/m2 for each 1 cm thickness
Compressive strength (min.) .................... 25 kgf/cm2 (4x4 block)
Flexural strength (min.) ... 10 kgf/cm2 (4x4x16 block)
Pass 1000 micron sieve ........................................ %100
Pass 150 micron sieve (min.) .......................... %60
Bulk density (powder) ............................ 750-800 kg/m3
Dry density ............................................ 950-1000 kg/m3
Thermal conductivity ..................................... 0,34 W/mK
Fire classification .......................................................... A1
Standard .............................................. TDS-31377-2008
Type .... B4/20/2 Light Weight Gypsum Building Plaster
Type................................. Polypropylene laminated bags
Weight ................................................................ 30 kg±%1
PROTECT FROM MOISTURE
FIRE RESISTANCE: A1
SOUND INSULATION: NPD
THERMAL INSULATION: NPD
MADE IN TURKMENISTAN
EASY TO USE
BASE TEMPERATURE
FOR INTERIOR USE
USAGE TIME 30 MINUTES
THICKNESS OF APPLICATION 5-40 MM.